Cable laying methods

1. What Matters Should Be Noted When Using The Torch?

Answer:

1. The maximum amount of oil injected into the torch is 3/4 of the volume of the oil drum.
2. Do not start pumping too much pressure. Also, ignite the flame from yellow to blue can be used.
3. There should be no flammable materials around the wire and cable, and there should be adequate air circulation.
4. Close the regulating switch when stopped. After the fire is extinguished, slowly screw loose the oil hole cover to release the air. After the air is released, screw loose the regulating switch, completely cool, and then screw open the hole cover.
5. Paraffin torch and gasoline torch should be used separately.

2.What Is The Use Of Manual Oil Pressure Pliers? How To Operate?

Answer: The connection of two wires and cables is usually the end of the two wires into the same material made of a pressure tube. Crimping pliers squeeze several pits so that the wires are connected. When the crimping handle is lifted, the plunger moves outward into the lower cavity of the oil valve to produce a vacuum.  The oil in the oil tank is pushed into the plunger cavity.

When the handle is pressed down, the plunger moves inward, and the oil is pressurized so that the inlet valve is closed. The outlet valve opens so that the oil pressure goes into the hydraulic cylinder. When pushed, the piston and Yang die, Yang, Yin die are placed between the pressure tubes. When the crimp is squeezed pit deep to a particular value, the return valve opens, the piston automatically returns. After pressing the recess, move the pressure clamp and then press the next one.